Reasons for the shedding of aluminum honeycomb panels and daily cleaning matters

Aluminum honeycomb panel materials have gradually been used in everyone's houses. Of course, the daily cleaning and maintenance of the aluminum honeycomb panel ceiling is also essential! So how to clean the aluminum honeycomb panels in the kitchen and bathroom? Let's take a look together below.

　　Reasons for the aluminum honeycomb panel to fall off

　　1. There is a hollow drum on the top of the aluminum honeycomb panel or it is not completely fixed

　　Aluminum honeycomb panel wholesale manufacturer stated that the installation of aluminum honeycomb panel also stipulates that the bottom of the concrete floor must be cleaned up in the construction process and design plan, without hollowing, cracking and cleaning, so that it can be observed and fixed during installation.

　　2. The construction technology is not good enough: During the whole process of the installation of aluminum honeycomb panels, the installers usually use their own work experience in engineering construction. Because of the uneven quality of the employees, the bottom of the concrete floor cannot be fixed well with the top of the ceiling; aluminum honeycomb The panel wholesaler stated that during the whole process of fixing the ceiling aluminum honeycomb panel, the concrete mix ratio is not strictly controlled, and there is no strict construction according to the relevant design plans and standards. May cause the aluminum honeycomb panel to fall off.

　　3. External force action level:

　　Of course, is not all due to the ceiling. Wholesale manufacturers of aluminum honeycomb panels say that external forces are inevitable. Since the concrete floor slab has to bear various loads, it is very much an external force that makes the concrete floor vibrate. That way, it is very easy to cause the separation between the bottom of the concrete floor and the fixed point, which will cause the aluminum honeycomb panel to fall off!

　　Daily cleaning of aluminum honeycomb panel

　　During normal use of aluminum honeycomb panels, you should always pay attention to daily cleaning and maintenance, especially in areas with heavy oily smoke and humidity such as kitchens and bathrooms. Long-term failure to deal with will speed up the process of corrosion of aluminum honeycomb panels and reduce them. Life, aluminum honeycomb panel manufacturers say that as long as the daily cleaning is good, it will naturally last a few years! Aluminum honeycomb panel manufacturers say that when cleaning the aluminum honeycomb ceiling, be careful not to use sandpaper, sander, wire brush, strong cleaning or metal Material-specific tools to clean the aluminum honeycomb ceiling.

　　Oil stains, paints, printing inks and other special dirt can be scrubbed with special scouring oil; daily cleaning should be done with a wet towel or wipe with a towel. In short, aluminum honeycomb panel manufacturers say that they cannot use strong acid and strong lye to clean the aluminum honeycomb. Board ceiling.

　　The above is an introduction to the reasons for the aluminum honeycomb panel falling off and the daily cleaning items. I hope that everyone will be helpful after understanding the reasons for the aluminum honeycomb panel falling off and the daily cleaning items.